3D Prints NW Oregon

For February, any order over $75, gets you a free gas cap drink holder in orange or black.

Going out today.. simple yet another solution for the mtn side sippin.

One stop shop for holding ur finest drink while at the mtn..

Finished up some bar ends and looking to have a few people test them. I have one set going out to someone already but would like to have 4-5 tests done. Parts will be free, just cover the 4-6 bucks in shipping in states. Lemme know if interested.

New design for the shock clicker tool. Flatter handle and +4mm diameter shaft.

Merry Christmas!!!! Thank you all for your support and business.

Had a request for the ignition key nut so figured id get the tether nut also..

Not sure i’ll crank these out like the tank nut tool.. but im tossing sets in my shop and trailer.

Just a heads up on delays.. were flooding here which has caused power outages on me numerous times which in turns kills the print. I have generator power for emergencies but interruption of the prints causes print quality to be sacrificed a bit and I wont ship out garbage.. soo ive had to reset about 10 times now.

Anyway, I appreciate your patience while I get all these orders out to u guys. P22, P85 clutch tools are pretty well stocked (this week) as are the tank nut removal tool. All of these items move fast tho so get your orders in through me or as always via Mountain Side Performance or Whiskey Throttle Powersports.

Thank you!!!

Parts are getting piled up for the tank nut removal tool. Will be starting to push out orders tomorrow and through next week. Cost is going to be set at $25 as I had to replenish stock which had increased costs that I cant eat all of.

Appreciate the excitement and I’ll be going down the list getting them pushed out.