Zane - Dallas TX USA

To bad finish sanding isn’t as quick as swiping right.

Another shot. Check out the figuring in the grain on the left and right sides.

All walnut everything.

First post in awhile, life and work have been super busy the last few months. We are about 30 days out from TDCC Shop 2.0 starting up when we close on the new house next month. Hope everyone is doing well.

Happy Sunday IG. Cherry walnut and mahogany end grain. Roughly 16x24x2 with a heavy chamfer.

Another chamfered board. This one was hUGE. How is everyone doing? I’ve been a little MIA with life lately!

cherry walnut and mahogany.

Happy Tuesday.

Details. I cut my chamfered edges about half way through finish sanding and I use high grit foam sanding blocks to make sure the edge stays tight.

Cherry walnut and mahogany. This one has classic vibe with a contemporary look.

TDCC is about a month and a half from having shop 2.0. Will probably take about the same amount get setup and running. I don’t plan to produce at the same rate as I have over the last couple of years but there are more than a few fun builds already on the books!

Walnut and mahogany 🇺🇸.

So much depth in this one. This board was 14”x24”x2”.

Walnut and mahogany 🇺🇸.