bike-fixed

Downhill weapon time, this Saracen Myst was in for a service along with needing a new axle which had been seriously rounded off after being overtightened way too much - not a problem, old one extracted and new one installed and torqued to spec

Beast! Super73 next up for a General Service after a few weeks of use since the customer built it from the box. Also needed new front pads & rotor due to contamination causing one of the brakes to howl 🐺 There was a few loose nuts & screws on this one, along with barely tightened pedals... it's 💯% worth having your new bike checked over after being box built, or get us in to build it for you! Then you can ride it worry free knowing it's set-up, adjusted and working perfectly for you from the very first pedal 🤓

Ok, this could fit buuuut I'm not strong enough to get it in alone, anyways the sun's out so why not work in the street 🌞This is one heavy cargo trike in need of a service, so the mobile workstand came to the rescue holding this one up 💪 Now serviced and every single nut/bolt on that box checked too as it carries my customers precious cargo 🚸

Busy one out at getting some of the ad bikes ready for the next round of campaigns 💪

Nice Specialized Jynx in for a service plus new rear tyre. Running tubeless the old tyre was degraded and had a big slit in the sidewall which was too bad for any amount of good sealant to seal up so new tyres definitely needed

The workstand is getting a lil workout holding this up for me - a bike in for a service plus new brake pads and tyres, old tyres had turned to slicks making this a very twitchy dangerous ride especially in the wet! Having brake pads badly worn on any bike is not good but even moreso on a chunky, powerful e-bike like this beaut mobilebikerepair

The workstand is getting a lil workout holding this up for me - a bike in for a service plus new brake pads and tyres, old tyres had turned to slicks making this a very twitchy dangerous ride especially in the wet! Having brake pads badly worn on any bike is not good but even moreso on a chunky, powerful e-bike like this beaut mobilebikerepair

Volt electric bike in for a 35 Point Full Service, along with replacement of some worn parts - bottom bracket bearings, chain, cassette, brake pads, jockey wheels and rear mudguard which had snapped and been cable tied. This very specific fitting mudguard wasn't available anymore from the supplier, however a branded one was customised with all fittings and adapted to fit perfectly. With a full Service plus parts it's running like a new bike again

Looks like a motorbike, but with pedals! This awesome looking beast Cooler Kub electric bike was in for some new tyres, brake pads and a service - check out the slick rear tyre, all tread worn away completely 😬 Awkward to get off the ground due to having nowhere to clamp it in my main workstand, so I got out the foldable workstand to carry the load making it much easier to work on
Again, the new mobile workshop coming in clutch with the ability to get these larger rides inside the van and out of the weather so I can get them sorted in the dry 🌧️🌧️🌧️🌧️🌧️🌧️🌧️

Just a few of the bikes that have been in and out the Bike-fixed recently(the ones I remembered to photo)... Hard working commuters, fast & light speed machines, chunky hard hitting full sus ebikes and everything in-between. We can sort them all, usually on-site which reduces the amount of time you are without your pride & joy to a minimum 🚐💨

Throwback to the previous (ol' reliable) which couldn't fit this recumbent in due to it having one little side door. Buuuut still got it fully serviced, cleaned and running perfectly again. Next time I'll be able to work on it inside the new Bike-fixed mobile workshop thanks to it's huge doors 🤓👍

YES!! Tiny received his donated bike after the one which had got him all but 130 miles to the finish was stolen by some dirty P.O.S in Poole 🙄
But, the donated bike needed a lot of TLC, chain was being sucked into the chainstays, rear hub was making some nasty sounds, brakes were rubbing, grips were slipping...
One new crankset, set of grips, complete rear hub overhaul, 2 tubes worth of innertube sealant and a bit of a once over service later the bike is ready to get him to the finish line in Plymouth 😎
TINY'S GB Cycle Ride has got some stories to tell, and I'm sure he'll have more from the last leg to the finish (HE SHOULD WRITE A BOOK ABOUT HIS JOURNEY 👍)

Give him a follow, like his page and make a donation to an amazing cause 🙏

https://www.gofundme.com/f/cycle-the-british-coast-for-british-veterans?utm_campaign=p_cp+share-sheet&utm_content=undefined&utm_medium=copy_link_all&utm_source=customer&utm_term=undefined

https://www.facebook.com/groups/855882905097818/?ref=share